PFD BRIGHTNESS CONTROL KNOB ROTATE (rotary action, detent at OFF)

ROTATE - manually adjusts brightness of respective side PFD OFF - Display Unit (DU) goes blank

MFD BRIGHTNESS CONTROL KNOB (rotary action, detent at OFF)

ROTATE - manually adjusts brightness of respective side MFD OFF - Display Unit (DU) goes blank

BEARING 1 SELECTOR knob (5 position, rotary action)

ROTATE - selects desired navigation source to be displayed by the white, single bar bearing pointer with a white circle, on the PFD

• selectable positions are labeled OFF, VOR 1, ADF 1, FMS 1 and AUX 1
• bearing pointer is removed from PFD display when turned OFF
• selected navigation source is annunciated on the PFD
• If VOR is selected, but the frequency is either invalid, or an ILS frequency, the pointer will be removed from view
• If ADF is selected, but the signal of frequency is invalid, the pointer will park at the 90° position
• If FMS is selected, and the FMS is operating, the pointer will point to the next waypoint
• AUX is only functional with optional equipment, i.e., MLS

FORMAT PUSHBUTTON (momentary action, 1 second hold)

PUSH 1 - ARC mode with VOR/ILS as navigation source PUSH 2 - ARC mode with MLS (if installed) as navigation source PUSH 2/3 - the NAV display on MFD changes back to ARC mode with FMS (default selection) as navigation source. This partial compass mode displays ± 45° around the current heading PUSH and HOLD (1 sec) - the NAV display on MFD changes to a FULL mode, A/C centered, oriented with respect to north. Optional navigation data may be displayed in that mode, using the DATA pushbutton, but not the weather radar image

TCAS PUSHBUTTON (momentary action)

PUSH 1 - shows TCAS traffic continuously when navigation page is set to arc or map Mode and range is set to 40 nautical miles or less,

• TCAS range ring indication comes into view to show continuous indication selection. PUSH 2 - automatic mode is activated. NOTE: If the EFCP malfunctions, the TCAS automatic mode is set.

WX/TERR PUSHBUTTON (momentary action)